Quartus II Web Edition 12.0sp2 not communicating with USB-Blaster on OpenSuSe 12.1

I have succesfully installed Quartus II Web Edition 12.0sp2 on OpenSuSe KDE4 12.1 x86_64.

Quartus II is working in 32 bit operation. (not configured as 64bit during installation)

I have an sample project succesfully compiled without any errors on Quartus II.

But when i try to programm the .sof file to my EP3C25 Starterboard, the programmer doesn’t show the USB-Blaster in the programmer configure window.

If I start de command “hwinfo --usb” by terminal in su mode I get the following output info;

14: USB 00.0: 0000 Unclassified device
[Created at usb.122]
Unique ID: ZmS7.7UPKMDz+LLB
Parent ID: 7eqy.v+N+B0xY+P6
SysFS ID: /devices/pci0000:00/0000:00:1d.0/usb6/6-1/6-1:1.0
SysFS BusID: 6-1:1.0
Hardware Class: unknown
Model: “Altera USB-Blaster”
Hotplug: USB
Vendor: usb 0x09fb “Altera”
Device: usb 0x6001 “USB-Blaster”
Revision: “4.00”
Serial ID: “91d28408”
Speed: 12 Mbps
Module Alias: "usb:v09FBp6001d0400dc00dsc00dp00icFFiscFFipFF "
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #8 (Hub)

So far conclusion SuSe is detecting the USB-Blaster

But when I start the command “jtagconfig” I get the following message;

hkopp64@linux-y0kk:~/altera/12.0sp2/quartus/bin> jtagconfig
*** The Quartus II software cannot be started because the current platform,
‘linux64’, does not appear to be installed in:
‘/home/hkopp64/altera/12.0sp2/quartus’.

Error (Server error) when scanning hardware
hkopp64@linux-y0kk:~/altera/12.0sp2/quartus/bin>

Quartus II jtag programmer is pointing to a 64bit dir, but how can I correct this to get the programmer working with the USB-Blaster into 32 bit operation ?

Kind Regards

Huib

:\

Hallo, welkom hier Huib,

Zou je de post in het nederlands kunnen doen, of moet ik hem verplaatsen naar de engelstalige forums?

Hij mag verplaatst worden naar de engelstalige forum.

Ik zal hem hier nog maals plaatsen maar dan in het nederlands

geen probleem

Moved to the Englsih language Hardware sub-forum.