I started to use CCS from texas instruments and Im using the xds100v1 jtag. Im able to debug the board but If i use another ftdi device along with the jtag I can’t debug the board. The jtag is unable to load program due to the other device been attached, only removing the other ftdi device I can again be able to program the board.
I guess is something about the udev rules, and I tried this:
1)add the ftdi device in udev rules, by using the dmesg i got the VID and PID
2)SYMLINK to this device in the udev rules
I already send message to the TI support but they said this OS is not supported.
Did anybody in here uses TI jtag?