wireless

wireless dont’ work

i hope that this information can help to find the probleme and solution

linux-q556:~ # uname -r
2.6.27.19-5-pae

lspci -v

10:00.0 Network controller: Broadcom Corporation BCM4312 802.11b/g (rev 01)
Subsystem: Hewlett-Packard Company BCM4312 802.11b/g Wireless LAN Controller
Flags: bus master, fast devsel, latency 0, IRQ 10
Memory at e4000000 (64-bit, non-prefetchable) [size=16]
Capabilities: [40] Power Management version 3
Capabilities: [58] Vendor Specific Information <?>
Capabilities: [e8] Message Signalled Interrupts: Mask- 64bit+ Count=1/1 Enable-
Capabilities: [d0] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting
UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSVoil-
UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSVoil-
UESvrt: DLP+ SDES- TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSVoil-
CESta: RxErr+ BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr-
CESta: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+
AERCap: First Error Pointer: 00, GenCap+ CGenEn- ChkCap+ ChkEn-
Capabilities: [13c] Virtual Channel <?>
Capabilities: [160] Device Serial Number 21-00-4d-ff-ff-00-a4-82
Capabilities: [16c] Power Budgeting <?>

linux-q556:~ # iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

pan0 no wireless extensions.

linux-q556:~ # ifconfig wlan0 up
wlan0: unknown interface: No such device
linux-q556:~ # sudo /usr/sbin/iwlist scan
lo Interface doesn’t support scanning.

eth0 Interface doesn’t support scanning.

pan0 Interface doesn’t support scanning.

– linux-q556:~ # dmesg | grep firmware
firmware: requesting intel-ucode/06-16-01

– udi /org/freedesktop/hal/devices/pci_14e4_4315

– i dont’fin kernel driver in information sys under wireless lan controler

other information
linux-q556:~ # ifconfig
eth0 Link encap:Ethernet HWaddr 00:1F:29:AB:07:0E
inet6 addr: fe80::21f:29ff:feab:70e/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:16262 errors:0 dropped:0 overruns:0 frame:0
TX packets:17040 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:12227402 (11.6 Mb) TX bytes:3182748 (3.0 Mb)
Memory:e4600000-e4620000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:32 errors:0 dropped:0 overruns:0 frame:0
TX packets:32 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2280 (2.2 Kb) TX bytes:2280 (2.2 Kb)

linux-q556:~ # sudo /usr/sbin/install_bcm43xx_firmware
sudo: /usr/sbin/install_bcm43xx_firmware: command not found

linux-q556:~ # “/sbin/ifconfig”
eth0 Link encap:Ethernet HWaddr 00:1F:29:AB:07:0E
inet addr:192.168.0.14 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::21f:29ff:feab:70e/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:17579 errors:0 dropped:0 overruns:0 frame:0
TX packets:18398 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:13110195 (12.5 Mb) TX bytes:3412939 (3.2 Mb)
Memory:e4600000-e4620000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:96 errors:0 dropped:0 overruns:0 frame:0
TX packets:96 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:7464 (7.2 Kb) TX bytes:7464 (7.2 Kb)

pan0 Link encap:Ethernet HWaddr 66:0E:15:9C:36:75
inet6 addr: fe80::640e:15ff:fe9c:3675/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:16 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:1064 (1.0 Kb)

thank for help[/size]

Wireless issues are better discussed in the wireless forum.

If you go to that forum and search for Broadcom, you will find that the 4315
devices are not handled by ANY in-kernel driver.

The solution is to use the Broadcom-wl driver. There are many postings that will
tell you how to obtain and install it.