Greetings,
I installed SuSE 11.1 64 bit. Previously, I had SuSE 11.1 32 bit. The wireless adapter will not grab an ip address from dhcpcd but the lan connection will. The wireless adapter worked properly with SuSE 11.1 32 bit. Here is the output after running this command /etc/init.d/network restart:
Shutting down network interfaces:
eth0 device: nVidia Corporation CK804 Ethernet Controller (rev a3)
eth0 done
eth1 device: Marvell Technology Group Ltd. 88E8001 Gigabit Ethernet Controller (rev 13)
No configuration found for eth1
Nevertheless the interface will be shut down.
eth1 done
wlan0 name: BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller
wlan0 done
Shutting down service network . . . . . . . . . done
Hint: you may set mandatory devices in /etc/sysconfig/network/config
Setting up network interfaces:
eth0 device: nVidia Corporation CK804 Ethernet Controller (rev a3)
eth0 Starting DHCP4 client.
eth0 IP address: 192.168.1.106/24
eth0 done
eth1 device: Marvell Technology Group Ltd. 88E8001 Gigabit Ethernet Controller (rev 13)
No configuration found for eth1
eth1 unused
wlan0 name: BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller
wlan0 warning: WPA configured but may be unsupported
wlan0 warning: by this device
wlan0 starting wpa_supplicant
wlan0 Starting DHCP4 client. . . . . . . .
wlan0 DHCP4 continues in background
wlan0 waiting
Setting up service network . . . . . . . . . . done
SuSEfirewall2: Setting up rules from /etc/sysconfig/SuSEfirewall2 …
SuSEfirewall2: using default zone ‘ext’ for interface eth1
SuSEfirewall2: using default zone ‘ext’ for interface wmaster0
SuSEfirewall2: batch committing…
SuSEfirewall2: Firewall rules successfully set
If you need anymore information I will try to supply it!
THKS,
Uans