Wireless Problem

I have configured my device in Yast but my laptop won’t connect to the network. Not sure what to do.

0001:10:11.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)

0001:10:11.0 0280: 14e4:4318 (rev 02)

wlan0 IEEE 802.11g ESSID:""
Mode:Managed Channel:0 Access Point: Not-Associated
Tx-Power=0 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

wlan0 Interface doesn’t support scanning : Network is down

Have you had a peek at the stickies at the start of the wireless section ? lots of useful info there


yes I have but I will look again.