wireless problem after shifting to 10.3

hello. i shifted my hp 2133’s SLED 10 to openSUSE 10.3; since then, i haven’t been able to use wireless. DSL works fine. I followed the sticky, here are the results:

> /sbin/lspci

02:00.0 Network controller: Broadcom Corporation BCM4310 USB Controller (rev 01)

07:03.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5788 Gigabit Ethernet (rev 03)

> /sbin/lspci-n

02:00.0 Class 0280: 14e4:4315 (rev 01)

07:03.0 Class 0200: 14e4:169c (rev 03)

> dmesg | less

eth0: Tigon3 [partno(BCM95788) rev 3003 PHY(5705)] (PCI:33MHz:32-bit) 10/100/1000Base-T Ethernet 00:1f:29:98:75:3a

eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] WireSpeed[0] TSOcap[1]

eth0: dma_rwctrl[763f0000] dma_mask[32-bit]

help please?

Tried installing the firmware as per lwfinger’s instructions ?


BCM4310 USB does not work with b43 (yet).

You need to use ndiswrapper, which is what you must have been using
with 10.3


nope didnt try installing firmware, is that what i’m missing?
how do i use ndiswrapper?
sorry. too much of a confused penguin here. it’s my first time to use a linux

As larry has pointed out,b43 doesn’t work with your device, so you won’t be able to use it for the firmware. Ndiswrapper howto’s are here and Ndiswrapper - openSUSE


hello, confused penguin here again.
already did the ff:

  1. installed ndiswrapper from the suse dvd
  2. downloaded the windows driver from the hp website… its a .exe file.
  3. figured i needed wine, so downloaded a package, it’s now in my desktop… problem is, dunno how to install it.

i need to install wine, use it to run the driver setup, then run ndiswrapper, correct?

any howtos on these?:shame: