Wireless not working Compaq 6910p Intel 4965 AG or AGN

I am running openSUSE 11.3 updated with all the latest patches and I cannot connect to my wireless router. I am running Linux Mint 10 on the same type of notebook HP Compaq 6910p and it worked right after the install. If I take off the security WPA & WPA2 Personal I can connect. Any thoughts?

lspci -v | less shows this for my wireless card.

10:00.0 Network controller: Intel Corporation PRO/Wireless 4965 AG or AGN [Kedron] Network Connection (rev 61)
Subsystem: Intel Corporation Device 1000
Flags: bus master, fast devsel, latency 0, IRQ 29
Memory at e4000000 (64-bit, non-prefetchable) [size=8]
Capabilities: [c8] Power Management version 3
Capabilities: [d0] MSI: Enable+ Count=1/1 Maskable- 64bit+
Capabilities: [e0] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting
Capabilities: [140] Device Serial Number 00-13-e8-ff-ff-79-21-01
Kernel driver in use: iwlagn

I am using the same settings for both notebooks just can’t figure out why openSUSE 11.3 won’t connect. I get the prompt to key in my password, I’ve even checked the box to show password to make sure I was keying it in correctly. Everything was good but it just goes right back to the password prompt after it fails trying to connect.[/size]

Hi,

Can you provide the result of this command just to be sure :

hwinfo --network

hwinfo --network

34: None 00.0: 10700 Loopback
[Created at net.124]
Unique ID: ZsBS.GQNx7L4uPNA
SysFS ID: /class/net/lo
Hardware Class: network interface
Model: “Loopback network interface”
Device File: lo
Link detected: yes
Config Status: cfg=new, avail=yes, need=no, active=unknown

35: None 00.0: 10701 Ethernet
[Created at net.124]
Unique ID: usDW.ndpeucax6V1
Parent ID: rBUF.YpNLmSD2bbD
SysFS ID: /class/net/eth0
SysFS Device Link: /devices/pci0000:00/0000:00:19.0
Hardware Class: network interface
Model: “Ethernet network interface”
Driver: “e1000e”
Driver Modules: “e1000e”
Device File: eth0
HW Address: 00:1b:38:7f:1e:3a
Link detected: no
Config Status: cfg=new, avail=yes, need=no, active=unknown
Attached to: #7 (Ethernet controller)

36: None 00.0: 1070a WLAN
[Created at net.124]
Unique ID: AYEt.QXn1l67RSa1
Parent ID: y9sn._1m5Wpe_NaE
SysFS ID: /class/net/wlan0
SysFS Device Link: /devices/pci0000:00/0000:00:1c.1/0000:10:00.0
Hardware Class: network interface
Model: “WLAN network interface”
Driver: “iwlagn”
Driver Modules: “iwlagn”
Device File: wlan0
HW Address: 00:13:e8:79:21:01
Link detected: yes
Config Status: cfg=new, avail=yes, need=no, active=unknown
Attached to: #22 (Network controller)

I pulled a Windows move and rebooted and my wireless now connects. Go figure? Thanks.