After installation of Suse 11.1 and downloading the latest driver for the graphic card( ATI Catalyst™ Proprietary Display Driver ) following the instruction to set it up my laptop (HP 615 Compag), doesn’t recognize my monitor. The screen has still the SUSE standard setup.
Next i’ve tried ‘‘sax2 -r’’ to get into the monitor configuration. The graphic card is correctly recognized.
By looking into the yast2-system-hardware information an unknown screen (AUO) is detected.
In sax2 I cannot select a monitor, which matches the resolution(1366x768). I selected an standard VESA monitor and pressed the TEST-Button. The screen went dark for two seconds and sax2 came back with the message ‘‘No configuration found’’ and a link to the ‘‘Xorg.99.log’’ file.
By looking into it, I found a couple of error messages, but I’m now a bit puzzled.
Here are the last couple of lines of the log-file:
*(==) RADEONHD(0): RGB weight 888
(==) RADEONHD(0): Default visual is TrueColor
(==) RADEONHD(0): Using gamma correction (1.0, 1.0, 1.0)
(II) RADEONHD(0): Validating Fixed Modes from Monitor “LVDS Panel”
on Connector “PANEL”
(II) RADEONHD(0): Rejected mode “1366x768” (1366x768:69.3Mhz): illegal horizontal timings
(EE) RADEONHD(0): No valid modes found
(II) RADEONHD(0): Destroying DAC A
(II) RADEONHD(0): Destroying UNIPHY_KLDSKP_LVTMA
(II) RADEONHD(0): I2C bus “RHD I2C line 0” removed.
(II) RADEONHD(0): I2C device “RHD I2C line 1:ddc2” removed.
(II) RADEONHD(0): I2C bus “RHD I2C line 1” removed.
(II) RADEONHD(0): I2C bus “RHD I2C line 2” removed.
(II) RADEONHD(0): I2C bus “RHD I2C line 3” removed.
(II) UnloadModule: “radeonhd”
(EE) Screen(s) found, but none have a usable configuration.
Fatal server error:
no screens found*
Does anybody have an idea, what’s going on and can help?