hey ppls… I’m sorry to bother you with minor problem but for me it’s a
quite large one :D… I’ve setup in one office a suse server and I’m
more then satisfied how it functions…except one problem… during the
day everything is fine but then after they close and come back in the
morning they cannot access it… I find the screen back and it wont come
back to either the welcome screen nor the desktop… the server then
needs to be restarted… so I’ve tried to figure out how to control
power management but without success (amateur … found on the
internet that (but I’m not sure) the power is controlled over powerdevil
but I cannot start the service… so pls if you have a small guide how to
make server always on help me…
ok… I think I’ve got something…still I didn’t find in system
management anything that has something to do with power… but I did
manage to switch the power option over krunner… I found in help that I
should be able to run powerdevil over krunner to fully manage power
options but it didn’t work… so if any ideas pls respond (command line
or something)… in services I found powerdevil but as I try to enable
it I get error 7…
it seems its not a problem with power… got a call that it froze today
about 10 times… it used to work on 9.2 little bit slower but there
where no such problems until I switched to v.11 so ppls if you have any
ideas where to start I would be more then grateful… the only change
I’ve made is that I’ve switched file system to reiser…
… found on the