opensuse 13.2 is not working Dracut errors help help

English Install/Boot/Login
1

fresh install opensuse 13.2

install went well no errors it formatted raid part1 and raid part3 with etx4

at the point of reboot i have dracut errors

the system dont recognized the raid-array raid 0 part1 /boot part2 swap part3 /
i has to boot from part1 /boot

after a hole lot of nothing the system stops in a dracut sreen

it says raid-array part 1 and part 2 are not found

i can see this by pressing F4 on a green screen with black rings on it.

A zypper dup from installed 13.1 gives the same trouble

2

Some searching on internet how dracut is working i find the possible trouble

dracut takes the names for the disks or raid part from how udev sees them
thats not what is in fstab
that says why the raid parts are not to find
udev gives the names of the 2 ssd’s together raid 0 3 parts ( mount points )

So dracut “never” can handle a raid array there the parts are not seen by udev but written down in fstab during install

Give us back MKINIT that works as in 13.1