OpenSuse 13.1 switched to NetworkManager mode. I don’t know why. Now I try to switch back to traditional ifup mode in YAST network config but it doesn’t save the settings! Does anyone know a way to switch back by terminal?
Regards, Sven
On 02/13/2014 05:26 PM, svenwappler pecked at the keyboard and wrote:
> OpenSuse 13.1 switched to NetworkManager mode. I don’t know why. Now I
> try to switch back to traditional ifup mode in YAST network config but
> it doesn’t save the settings! Does anyone know a way to switch back by
> terminal?
>
> Regards, Sven
>
>
Just in case you haven’t.
When you launch “Network Settings” in YaST you need to select the left
most tab which is where the selection can be made.
Ken
Yes, but this is exactly my problem. YaST doesn’t save my choice. And know I have problems to bring my server online. That’s why I asked for a way by terminal.
On 02/13/2014 09:16 PM, svenwappler pecked at the keyboard and wrote:
> Yes, but this is exactly my problem. YaST doesn’t save my choice. And
> know I have problems to bring my server online. That’s why I asked for a
> way by terminal.
>
>
On the terminal (CLI) use the ip command:
ip link set { dev DEVICE | group DEVGROUP } { up | down } ]
ip link set dev eth0 up
Sub your actual device for dev. And
ip link help
is your friend.
Ken
On 2014-02-14 03:16, svenwappler wrote:
>
> Yes, but this is exactly my problem. YaST doesn’t save my choice. And
> know I have problems to bring my server online. That’s why I asked for a
> way by terminal.
Strange.
You could try uninstall network manager.
–
Cheers / Saludos,
Carlos E. R.
(from 13.1 x86_64 “Bottle” (Minas Tirith))
systemctl disable NetworkManager
It may be useful to show output of “systemctl status network” before doing it. May be it is already done and you have some other issues.
You can also type “yast” in a console (not yast2) and it should launch yast in ncurses mode (text mode) with the same ability to enable/disable Network Manager.
TSU