Guten Abend zusammen,
ich habe mich nun mit meinem Notebook ( HP ProBook 6450b ) an OpenSuSE gewagt da ich bis daher nur gutes zu hören bekommen habe.
Nun habe ich SuSE installiert aber mein WLan geht nicht habe mich schon in viele Foren um gesehen und herraus gefunden wie Karte wird erkannt aber evt. nicht installiert wo ich mich frage warum?
Ein paar Informationen:
lspci -vnn | grep 14e4 hat ergeben:
44:00.0 Network controller [0280]: Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller [14e4:4727] (rev 01)
lspci -vnn
44:00.0 Network controller [0280]: Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller [14e4:4727] (rev 01)
Subsystem: Hewlett-Packard Company Device [103c:145c]
Flags: bus master, fast devsel, latency 0, IRQ 19
Memory at d0500000 (64-bit, non-prefetchable) [size=16]
Capabilities: [40] Power Management version 3
Capabilities: [58] Vendor Specific Information: Len=78 <?>
Capabilities: [48] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [d0] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting
Capabilities: [13c] Virtual Channel
Capabilities: [160] Device Serial Number 00-00-12-ff-ff-72-ac-81
Capabilities: [16c] Power Budgeting <?>
Kernel driver in use: bcma-pci-bridge
linux-o7a2:/home/michael # lwlist scan
If 'lwlist' is not a typo you can use command-not-found to lookup the package that contains it, like this:
cnf lwlist
linux-o7a2:/home/michael # iwlist scan
eth0 Interface doesn't support scanning.
lo Interface doesn't support scanning.
linux-o7a2:/home/michael # ifconfig wlan0 up
wlan0: unbekannte Schnittstelle: Kein passendes Gerät gefunden
linux-o7a2:/home/michael # modprobe -r iwlagn
FATAL: Module iwlagn not found.
Hoffe mir kann jemand helfen.
Gruß Michael[/size]