The module e1000e is loaded into system. At addition VLAN the system hangs at a stop VLAN or configure other devices (sound, video).
What’s the problem?
In OpenSuSe 11.3 it worked correctly.
MB: ASUS P5Q-ME DO / NetCard: Intel 82567LM-3
Hello,
I can confirm this issue - even worse, Yast hangs when trying to access the “Network Settings”. Same for VirtualBox when bridged to
the Vlan interface on the e1000. The only way to get back to a working system is to remove the /etc/sysconfig/network/ifcfg* files for
the vlan interfaces.
lspci | grep Ether
00:19.0 Ethernet controller: Intel Corporation 82567LM-3 Gigabit Network Connection (rev 02)
hwinfo also hangs when e1000 + VLAN are in use. here’s my hwinfo after removing the VLAN:
19: PCI 19.0: 0200 Ethernet controller
[Created at pci.318]
Unique ID: rBUF.Cc0FRGO4Uo1
SysFS ID: /devices/pci0000:00/0000:00:19.0
SysFS BusID: 0000:00:19.0
Hardware Class: network
Model: “Intel 82567LM-3 Gigabit Network Connection”
Vendor: pci 0x8086 “Intel Corporation”
Device: pci 0x10de “82567LM-3 Gigabit Network Connection”
SubVendor: pci 0x17aa “Lenovo”
SubDevice: pci 0x3047
Revision: 0x02
Driver: “e1000e”
Driver Modules: “e1000e”
Device File: eth0
Memory Range: 0xfc500000-0xfc51ffff (rw,non-prefetchable)
Memory Range: 0xfc527000-0xfc527fff (rw,non-prefetchable)
I/O Ports: 0x1820-0x183f (rw)
IRQ: 44 (11624 events)
HW Address: 00:21:86:f6:2b:a6
Link detected: yes
Module Alias: “pci:v00008086d000010DEsv000017AAsd00003047bc02sc00i00”
Driver Info #0:
Driver Status: e1000e is active
Driver Activation Cmd: “modprobe e1000e”
Config Status: cfg=no, avail=yes, need=no, active=unknown