I just installed 11.1 with KDE on a Compaq desktop with an HP monitor. I
have not changed any settings at all.
Under Windows the monitor will power down to Standby mode, when I’m not
using it for a while. But with Suse 11.1, it goes black, but remains on
full power.
Is there some way I can configure it to work properly? Thanks.
Yes, I’m on KDE4.
Yes I’ve been to Personal Settings, Advanced, Power Management. I have
not changed anything.
Under General Settings:
It has a tick against Let PowerDevil manage screen powersaving.
Under Capabilities:
It has a tick against DPMS support (I seem to remember that is
something to do with monitor power?)
Status has a tick.
rgbeal;1916699 Wrote:
> I just installed 11.1 with KDE on a Compaq desktop with an HP monitor. I
> have not changed any settings at all.
>
> Under Windows the monitor will power down to Standby mode, when I’m not
> using it for a while. But with Suse 11.1, it goes black, but remains on
> full power.
>
> Is there some way I can configure it to work properly? Thanks.
I had the same issue with my installation of 11.1. Check to make sure
that the screen saver is not activated. Mine was but it was just going
to a black screen and not an actual saver. Once I turned off the screen
saver, my monitor would power off.
I am having a similar problem. I have 11.1 installed with KDE upgraded
to KDE 4.2 beta2. Before the upgrade, my monitor would suspend even
with the screen saver activated. Now, the screen won’t suspend.
I have two ways of power savings in my Personal Settings…
…Display>Power Control>Suspend, Standby
or, …Advanced>Power Management>Let Power Devil manage screen
saving…
Which one doe I use? Power Control, or Power Devil?
And according to this thread. I can have a screen saver OR, a monitor
that suspends, but NOT BOTH.
Huh? I normally have screen saver come on at 10 minutes. Then monitor
suspend at 30 minutes. It works in XP and it did work in suse 11.1.
Am I doing something wrong or did I break it with KDE 4.2 beta2?