I am trying to print a schematic from KPDF (Suse 11.2) onto an 11x17 sheet of paper. Regardless of the printer settings I use or which driver I choose it won’t rotate the image and fill the page. I have the same problem with kiCAD. If I use Okular it prints part of the drawing in one corner at the 8.5x11 scale. Does anyone have any suggestions?
Had the same problem way back though it is a brother printer. Sometimes it needs to turn off the printer and pull the plug from the electric current then load a substantial amount of 11X17 paper before turning it on again. Sometimes when the paper is just a few inside the sensor tend to malfunction.
The paper tray is full and I power down the printer every day. I just loaded the latest hplip-3.10.2.run drivers and installed them, NO CHANGE. It still prints the image centered in portrait regardless of the landscape / portrait setting.
Found something interesting. I am able to print 11X17 landscape from LTspice IV running in WINE. I hope this helps.