I have been a member of suse studio for a while, and have done a build a few times to play around with.
However, when I load the completed image into testdrive, I can only get as far as the licence agreement screen. How do I tell it that I accept the licence? I’ve tried the obvious things like entering yes, ok etc…nothing i’ve tried seems to work.
I would love to be able to run my builds in testdrive to play around with them, but I get stuck on this screen every time and can go no further.
I have also tried doing a search on the site to see if it’s mentioned anywhere how to get past this screen, but based on the fact it’s not listed anywhere, it must be blindingly obvious to everyone except me.
On 08/31/2010 07:56 PM, csc2ya wrote:
>
> I have been a member of suse studio for a while, and have done a build a
> few times to play around with.
>
> However, when I load the completed image into testdrive, I can only get
> as far as the licence agreement screen. How do I tell it that I accept
> the licence? I’ve tried the obvious things like entering yes, ok
> etc…nothing i’ve tried seems to work.
>
> I would love to be able to run my builds in testdrive to play around
> with them, but I get stuck on this screen every time and can go no
> further.
>
> I have also tried doing a search on the site to see if it’s mentioned
> anywhere how to get past this screen, but based on the fact it’s not
> listed anywhere, it must be blindingly obvious to everyone except me.
For SLE 11 appliances, you just have to hit “y” followed by the enter
key to accept the EULA.
It is a bit more tricky for SLE 10 appliances, where you have to pressed
“:q” before the EULA prompt appears.
This might sound stupid, but are you sure you actually see the entire testdrive “screen” … The reason I’m asking is because I can’t see the entire screen unless I use fullscreen in my browser by pushing F11 … This might of-course not be your issue, but it took me a few seconds to figure out why I could not see the accept buttons my selves
