802.1Q vlans problem (OpenSUSE 11.4 x86-64)

hello.

I’ve configured 802.1Q vlan by creating ifcfg-vlan56 and ifcfg-eth0.10 and got two new
interfaces vlan56 & eth0.10.
Nethwork is not work in vlans (VID56 & VID10). After /etc/init.d/network stop (or restart) my console hangs… Also hangs ifconfig command from other console. I’ve got network configuration files from my old 11.3 (i’ve installed 11.4 on my PC with disks format). I do this whith a same hardware. Now i’m back to 11.3. Vlans work fine. My hw is: GIGABYTE 890GPA-UD3H (RTL8111/8168B).

The message about e100e and vlans is like my problem.

my ifcfg-vlan56 file:
ETHERDEVICE=‘eth0’
IPADDR=‘1.1.1.100/25’
NETMASK=‘255.255.255.128’
NETWORK=‘1.1.1.0’
BROADCAST=‘1.1.1.127’
STARTMODE=‘auto’
PREFIXLEN=‘25’

Do you know about this bug? … about a fix?

Nick.

Have You disabled NetworkManager ?

Best regards,
Greg

Yes, I don’t use NetworkManager.

https://bugzilla.novell.com/show_bug.cgi?id=679685

A very similar message.

I’ve tested it with 11.4 i586 (as like x86_64). Without result.

What did I do:

I’ve got a new computer AMD3 AMD Phenom II (6 cores, 1055T), GIGABYTE 890GPA-UD3H, 4Gb DDR3,
create one file ifcfg-vlan56 after standart KDE installation by DVD disc of OpenSUSE 11.4,
configured an eth0 — any IP/mask. This is my ifcfg-vlan56 file:

ETHERDEVICE=‘eth0’
BOOTPROTO=‘dhcp’
BROADCAST=’’
ETHTOOL_OPTIONS=’’
IPADDR=’’
MTU=’’
NAME=’’
NETMASK=’’
NETWORK=’’
REMOTE_IPADDR=’’
STARTMODE=‘auto’
USERCONTROL=‘no’

I’ve got two interfaces: eth0 & vlan56 (do not get an IP from DHCP-server !!! Dhcpcd is worked.).
Then i can see: Terminal hangs while /etc/init.d/network stop (or restart).
Also I can’t to kill a dhcpcd by ‘killall -9 dhcpcd’ command. Reboot don’t work too (hangs on stoping vlan interface).

The same work fine with 11.3.

With hope to fix.
Nick.

This looks very strange and might be a bug of 11.4. Could You fill in a bug report on this ?

Best regards,
Greg