I have opensuse installed on my drive. I added a slave drive and want to install windows on this drive. Will I have grub issues if I just install windows on the slave drive?
Thanks
I have opensuse installed on my drive. I added a slave drive and want to install windows on this drive. Will I have grub issues if I just install windows on the slave drive?
Thanks
Normally, it is best to install Windows first and not last. Now here is a blog on the subject you need to read from oldcpu on the subject:
Installing Windows7 after openSUSE-11.4 - Blogs - openSUSE Forums
Next, I have a general blurb on install openSUSE and partitions:
Each hard drive can have up to four PRIMARY partitions, any of which could be marked active and bootable. No matter what you might hear, only one of the first four primary partitions can be booted from. That means you can boot from Primary partitions 1, 2, 3 or 4 and that is all. In order to boot openSUSE, you must load openSUSE and the grub boot loader into one of the first four partitions. Or, your second choice is to load the grub boot loader into the MBR (Master Boot Record) at the start of the disk. The MBR can be blank, like a new disk, it can contain a Windows partition booting code or generic booting code to boot the active partition 1, 2, 3, or 4. Or, as stated before, it can contain the grub boot loader. Why load grub into the MBR then? You do this so that you can “boot” openSUSE from a logical partition, numbered 5 or higher, which is not normally possible. In order to have more than four partitions, one of them (and only one can be assigned as extended) must be a extended partition. It is called an Extended Primary Partition, a container partition, it can be any one of the first four and it can contain one or more logical partitions within. Anytime you see partition numbers 5, 6 or higher for instance, they can only occur inside of the one and only Extended Primary partition you could have.
What does openSUSE want as far as partitions? It needs at minimum a SWAP partition and a “/” partition where all of your software is loaded. Further, it is recommended you create a separate /home partition, which makes it easier to upgrade or reload openSUSE without losing all of your settings. So, that is three more partitions you must add to what you have now. What must you do to load and boot openSUSE from an external hard drive? Number one, you must be able to select your external hard drive as the boot drive in your BIOS setup. Number two, you need to make sure that the external hard drive, perhaps /dev/sdb, is listed as the first hard drive in your grub device.map file and listed as drive hd0. I always suggest that you do not load grub into the MBR, but rather into the openSUSE “/” root primary partition which means a primary number of 1, 2, 3 or 4. If number one is used, then that will be out. You will mark the openSUSE partition as active for booting and finally you must load generic booting code into the MBR so that it will boot the openSUSE partition. I suggest a partition like this:
<OR>
I would read through all of this and contemplate your next move, before you make it.
Thank You,
thanks. will do some reading!!!
Before you start, please come back and outline your plan and ask for help. That is what we are here for. Now it can not be worse that installing Windows over openSUSE and then reinstalling openSUSE but oldcpu was able to make it work and it can be a learning experience for you and good luck.
Thank You,