I installed qt -recordmydesktop from repo"http://download.opensuse.org/repositories/home:/ecsos/openSUSE_Leap_42.1/"
i installed gtk-recordmydesktop from repo (gnome:app) but not recording
for working i must disable check box sound quality(working without sound)
i run with terminal but not show error in the terminal only show error mode GUI
I think my sound card is not complete install
I installed qt -recordmydesktop from “http://download.opensuse.org/repositories/home:/ecsos/openSUSE_Leap_42.1/”
i installed gtk-recordmydesktop from repo (gnome:app) but not recording
for working i must disable check box sound quality
I think my sound card is not complete install
i run with terminal but not show error in the terminal only show error mode GUI
#recordMyDesktop stderror output:Initial recording window is set to:
X:1024 Y:528 Width:342 Height:240
Adjusted recording window is set to:
X:1014 Y:528 Width:352 Height:240
Your window manager appears to be KWin
Detected compositing window manager.
Reverting to full screen capture at every frame.
To disable this check run with --no-wm-check
(though that is not advised, since it will probably produce faulty results).
Initializing...
Buffer size adjusted to 4096 from 4096 frames.
Couldn't open PCM device hw:0,0
Error while opening/configuring soundcard hw:0,0
Try running with the --no-sound or specify a correct device.
linux-ckm8:~> recordmydesktop --device pulse
Initial recording window is set to:
X:0 Y:0 Width:1366 Height:768
Adjusted recording window is set to:
X:6 Y:0 Width:1354 Height:768
Your window manager appears to be KWin
Detected compositing window manager.
Reverting to full screen capture at every frame.
To disable this check run with --no-wm-check
(though that is not advised, since it will probably produce faulty results).
Initializing...
Buffer size adjusted to 4096 from 4096 frames.
ALSA lib pcm.c:2267:(snd_pcm_open_noupdate) Unknown PCM pulse
Couldn't open PCM device pulse
Error while opening/configuring soundcard pulse
Try running with the --no-sound or specify a correct device.
Right on
after checked the settings tab in pavucontrol and installed “zypper install alsa-firmware”
Now Very good works
Thank you very much for help me