Results 1 to 2 of 2

Thread: Getting all layers to correctly see and be in a state display and use additional disk space

  1. #1

    Default Getting all layers to correctly see and be in a state display and use additional disk space

    Environment:
    SLES11 SP3
    1GB Physical drive (sdb)
    4 partitions (sdb1-sdb4)
    - sdb4 is a 8e (LVM) managed partition.
    - sdb4 starts where sdb3 ended and extends all the way to the end of the 1GB drive

    Therefore I can not create any more partition on the drive (fdisk) and there is no more free space on the drive

    Now, the disk was extended from its 1GB size to the size of 2GB...
    meaning at the end of sdb4 is ~1GB of unallocated space.

    Challenge: Get LVM to see the additional 1GB space so filesystems may be extended.

  2. #2
    Join Date
    Jun 2008
    Location
    Netherlands
    Posts
    29,775

    Default Re: Getting all layers to correctly see and be in a state display and use additional disk space

    Sorry, but these are NOT the SLES forums. These are the openSUSE forums.

    Better go for the SLES/SLED audience at: https://forums.suse.com/forum.php
    Same username and password as here.

    Thread will be closed.
    Last edited by malcolmlewis; 10-Apr-2014 at 06:12. Reason: Close thread as well.
    Henk van Velden

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •