Hello,
I’d like to clone an existing system using kiwi/autoyast. I’ve searched the documentation, but cannot figure out if it is possible to automagically create a clone of my system, including list of installed packages and whatever configuration changes I made manually. Any pointers you could give will be much appreciated.
Petr
On 2013-12-07 16:56, petr danecek wrote:
>
> Hello,
>
> I’d like to clone an existing system using kiwi/autoyast. I’ve searched
> the documentation, but cannot figure out if it is possible to
> automagically create a clone of my system, including list of installed
> packages and whatever configuration changes I made manually. Any
> pointers you could give will be much appreciated.
Autoyast is designed for that, but I don’t know how automatic it gets.
There is a yast module for it, try…
And there is documentation, I saw it time ago.
–
Cheers / Saludos,
Carlos E. R.
(from 12.3 x86_64 “Dartmouth” at Telcontar)
Yeah, there is a lot of documentation out there, but I was not able to find the relevant piece in it. Until now:
openSUSE-KIWI Image System.
The section 8.1 suggests to run
kiwi --describe workstation
I tried it and it seemed to run for a while, but then it ended up stuck consuming 100% CPU for hours, I had to kill it. Hopefully a bug that will get fixed soon. Thanks for your response.
On 2013-12-15 15:46, petr danecek wrote:
> Hopefully a bug that
> will get fixed soon.
Only if you report it in Bugzilla.
–
Cheers / Saludos,
Carlos E. R.
(from 12.3 x86_64 “Dartmouth” at Telcontar)