Very new to OpenSuse. I have downloaded opensuse 12.2 and tried to install on Intel D2500HN board.Everything is working fine but only problem is it is taking the optimal resolution for the monitor and I am unable to change the resolution and refresh rate also
Thanks in advance n any help may be appreciated.
I have a bash script that will run inxi who’s output you could post here in a message for a complete hardware listing. inxi comes from the Packman repository, which you must add first before you can use this utility. Have a look here:
Hi nishanth9042. A good idea to assist us here, would be to upload the contents of /var/log/Xorg.0.log to SUSE Paste
and post the link to it here. For example, it could be a driver issue, or it could be that your display does not pass correct EDID info, but the Xorg.0.log will help determine the cause, and maybe the solution too.
The intel (gma500) driver is not in use. For some reason the basic framebuffer driver is in use. This explains the low display resolution. Here’s the relevant output
1. 604.883] (--) FBDEV(0): Virtual size is 1280x768 (pitch 1280)
1. 604.883] (**) FBDEV(0): Built-in mode "current"
1. 604.883] (++) FBDEV(0): DPI set to (100, 100)
1. 604.883] (II) Loading sub module "fb"
1. 604.883] (II) LoadModule: "fb"
After reading a few Phoronix articles about this hardware, I can honestly say that I’m glad I don’t own hardware with it. What a messy situation! In reverse chronological order:
I’ve learned that the fbdev driver is the optimal driver for this hardware. (The kernel gma500_gfx DRM module is used to provide basic 2D acceleration only.) There is a ‘xf86-video-modesetting’ package available, which provides basic modesetting capability, but I confess that I know nothing about whether this will help your situation. So, your choice is to
On 2012-10-20 14:26, nishanth9042 wrote:
>
> Yes I have tried the post 10.after modifying it is booting to text mode
> i.e console screen.
>
> I also tried to change to gui by pressing CTRL+ALT+F7 and startxfce4
> but it is showing some error.
And do you expect us to help if you keep that “some error” as a state
secret? >:-P
–
Cheers / Saludos,
Carlos E. R.
(from 12.1 x86_64 “Asparagus” at Telcontar)
> 386.333] (==) Using system config directory "/usr/share/X11/xorg.conf.d"
> 386.343] Parse error on line 11 of section InputClass in file /etc/X11/xorg.conf.d/50-device.conf
> "°3É p4B·" is not a valid keyword in this section.
Correct that.
–
Cheers / Saludos,
Carlos E. R.
(from 12.1 x86_64 “Asparagus” at Telcontar)
I did tell you not to proceed with the advice in post #10, but after looking at the Xorg error, it looks like you’ve entered some other invalid entry anyway. Remove your changes with an editor, (either at runlevel 3, or via safe mode boot). In post #15, I’ve explained to leave as is, or the possibility of trying the ‘modesetting’ driver. Your options are limited with this hardware.