Results 1 to 2 of 2

Thread: rs232 (usb to serial) cable not detected, why?

  1. #1

    Smile rs232 (usb to serial) cable not detected, why?

    any suggestion about my problem, a few day ago i have checked my application and make rs232 cable converter to communicated it. And not detected, why?


    FYI,
    this is my lsusb command,



    but in my dmesg, was not found.
    check this out, (usualy there is another rows, just like ".....converted to ttyUSB0....")


    thanks
    regards

  2. #2
    Join Date
    Mar 2010
    Location
    Austin - Texas
    Posts
    10,140
    Blog Entries
    48

    Smile Re: rs232 (usb to serial) cable not detected, why?

    So, I have one of these inexpensive devices, perhaps the very same one, but it does show up for me.

    Code:
    lsusb (for only serial/USB adapter)
    Bus 002 Device 003: ID 067b:2303 Prolific Technology, Inc. PL2303 Serial Port
    dmesg | grep tty (for only serial/USB adapter)
    [12591.384983] usb 2-1.7: pl2303 converter now attached to ttyUSB0
    Perhaps it is an adapter gone bad? Or, perhaps it is a kernel version issue? I have updated to kernel 2.6.38-rc4, though I doubt you need one like that to use the adapter. On this computer I am still using openSUSE 11.2 as well. Tell us about your openSUSE setup.

    Thank You,
    My Blog: https://forums.opensuse.org/blogs/jdmcdaniel3/

    Software efficiency halves every 18 months, thus compensating for Moore's Law

    Its James again from Austin, Texas

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •