Can any offer some insight to Yast's default partioning of my two dinky hard drives? I have been reading up on partioning but do not quite understand all the types of filesystems that were created by default. I also plan to add much larger hard drive, but I have to remove one. Can anyone offer suggestion on how I should proceed?

[SIZE="4"][SIZE="2"]linux-p9kt:/home/sarnone # fdisk -l

Disk /dev/sda: 4512 MB, 4512701440 bytes
255 heads, 63 sectors/track, 548 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

Device Boot Start End Blocks Id System
/dev/sda1 1 2 16033+ 41 PPC PReP Boot
/dev/sda2 3 64 498015 82 Linux swap / Solaris
/dev/sda3 65 548 3887730 83 Linux

Disk /dev/sdb: 9100 MB, 9100369920 bytes
255 heads, 63 sectors/track, 1106 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

Device Boot Start End Blocks Id System
/dev/sdb1 128 1106 7863817+ f W95 Ext'd (LBA)
/dev/sdb2 4 127 996030 82 Linux swap / Solaris
/dev/sdb3 * 1 3 24066 6 FAT16
/dev/sdb5 128 520 3156741 83 Linux
/dev/sdb6 521 1106 4707013+ 83 Linux

Partition table entries are not in disk order


Thanks in advance.
Steve