Results 1 to 5 of 5

Thread: Internet router for small home network using openSUSE 11.1

  1. #1

    Default Internet router for small home network using openSUSE 11.1

    I intend to use openSUSE 11.1 for a Internet router for my small home network - I want to replace windows 2003.

    I have 3 ETH cards (1 for WAN and 2 for local network - I can also use just 1 card). My connection to the Internet is VDSL (I get an IP address using the ISP DHCP) and on the local network I have some Linux and some Windows clients which need access to the router for file sharing (probably Samba?). I also need remote access to the router for both Linux and Windows clients (probably VNC?). I will also need to run an eMule and Torrent client with Web Access (probably aMule and KTorrent?).

    I already found some tutorials:
    ICS - openSUSE
    openSUSE ICS: Internet Connection Sharing (Linux IP Masquerading) with Suse or Windows Servers

    What I want to know is if this would be enough to set up the Internet router.

  2. #2
    Join Date
    Jun 2008
    Location
    Taiwan
    Posts
    150

    Default Re: Internet router for small home network using openSUSE 11

    These tutorials are enough to build router box for your environment, but you only need to use 2 ethernet card
    one for External another one for Internal.
    If you want to use KTorrent, please shall attempt to use qBittorrent that is my a little bit opinion.
    Regards,
    Bryan Yu
    http://lifestory.moqin.com/

  3. #3

    Default Re: Internet router for small home network using openSUSE 11

    Thank you for directing me to qBittorrent. I think I read something about it some time ago, but when I looked at the feature list again I was sold

    About the 3 eth cards, it is just that I had them laying around and I think it also helps to distribute the load more evenly on both sides of the network. I have a network switch for 2 connections (2 neighbors) connected to one card, but then I also have a WLAN AP (with integrated switch) connected to the other card (1 local PC and up to 4 wireless clients) so I think I profit a few micro seconds

    I also forgot about some kind of network monitoring. Is it possible to monitor the amount of traffic from a specific IP address and possibly limit it?

  4. #4
    Join Date
    Jun 2008
    Location
    Taiwan
    Posts
    150

    Default Re: Internet router for small home network using openSUSE 11

    Here you can find the network monitor "NTOP" installation article, but if want to configure some rule to accept or deny or other limit, please use firewall tool.
    BSD/Linux Tutorial Zone: Ntop network analyzer installation procedure on openSUSE 11.0
    Regards,
    Bryan Yu
    http://lifestory.moqin.com/

  5. #5

    Default Re: Internet router for small home network using openSUSE 11

    So I set up my openSUSE router without a problem (it was really easy - much easier than windows 2003).

    I installed qBittorrrent but the web UI was a bit lacking in "settings" (you can't change any settings on it), so I had to go with KTorrent (it has a similar problem but I can now at least change the UL and DL limits).

    aMule is much better program for a "server configuration" compared to eMule, since it has the ability to connect to a remote instance (with aMuleGUI) and you basically control it like it was on your PC.

    I tried to use ntop but without sucess, but from what I have seen so far I no longer need it, since I don't have the same problems that I had with windows 2003 - for some unknown reason ping to the DNS server went up to 2000 ms an even bigger for other sites. I suspect that Linux firewall is more successful than the one from windows 2003.

    There is only one little problem I have with this setup. Remote administration is a bit trickier than on windows. Since I need a user that is always logged on and I have no monitor connected to the PC I can't connect to this session. If a monitor is not connected to the PC the x11vnc just shows me a black screen of that session but I can log in on a new session with VNC (with a viewer and from the browser) but at least for now I can live with it
    What I don't know is why don't I get asked for a password when I connect to the VNC session, I get to the openSUSE login manager whe I connect to a new session, but I think I should be asked for a password when I try to connect - can it be done, since it would make it more secure... I think this was set up using in Yast for VNC administration.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •