Results 1 to 4 of 4

Thread: Installation of Suse 11.1 Partition and Grub Problems

  1. #1

    Smile Installation of Suse 11.1 Partition and Grub Problems

    Hi as a beginner, I had a lot of problems and errors during installation of Suse 11.1 and one was this

    Code:
    Error Occurred While Installing GRUB
    
    Minimal BASH- like line editing is supported. For the first word. TAB lists possible command completions. Anywhere esle TAB lists the possible completions of a divice/filename]
    
    grub > setup--stage2= /boot/grub/stage2--force-iba (hd0,3)(hd0,5)
      Checking if "/boot/grub/stage1" exists... yes
      Checking if "/boot/grub/stage2" exists... yes
      Checking if "/boot/grub/e2fs-stage1-5" exists... yes
      Running "embeded/boot/grub/e2fs-stage1-5 (hd0,3)"... failed (this is not fatal)
      Running "intall--force-iba-stage2= /boot/grub/stage2/boot/grub/stage2/boot/grub/stage1 (hd0,3 /boot/grub/stage2 p /boot/grub/menue.1st"... failed
    
    Error 22: No such Partition
    
    grub > quite
    I couldn't fix the problem through system repair because I didn't know what to type into the section editor which gave this to edit:

    Code:
    Setion Name: Suse Linux
    Optional Kernal Commandline Parameter: repair=1 resume=/dev/disk/by-id/ata-Hitachi_HTSS41680J9SA00_SB2204SGCVWRME-part5 splash=silent showopts
    Kernal Image: /boot/vmlinuz
    Initial RAM Disk: /boot/initrd
    Root Device: WRME-part
    VGA Mode: 0x361
    
    Section Name: Failsafe
    Optional Kernal Commandline Parameter: showopts ide =nodm amp=off noresume edd=off powersaved=off nohz =off highres=off processor.max-cstate=1x11failsafe
    Kernal Image: /boot/initrd
    Root Device: WRME-part
    VGA Mode: 0x361
    I managed to load Suse/boot my hard drive only through the Super Grub Boot Disk. Still I am left without "proper" configuration and my munu.1st is empty, so I have no idea how GRUB is working.

    Is there a default code I can put into the Yast2 Boot configuration or when I am running a system repair.

    I think the problem may be to do with the partitions. Toshiba recover disks leave 3 partitions. One is a very small one for the recovery files and in addition to the main one there is basically an empty drive D where the language files were temporary stored. Hopefully I will get around this otherwise I may consider scrapping windows altogether. I am currently unable to boot Windows.

    I would appreciate your help on this. Thanks.

  2. #2
    Join Date
    Mar 2008
    Location
    Oz
    Posts
    11,731
    Blog Entries
    2

    Default Re: Installation of Suse 11.1 Partition and Grub Problems

    Try rebuilding the Grub menu file (menu.lst) with the following technique:
    go to Yast --> System --> Boot Loader. The Grub configuration screen comes up with the Tab "Section Management" activated. In the lower right is a drop-down selector labelled "Other". Select from "Other" the option "Propose New Configuration" and then wait for Grub to analyse your partitions and display a new configuration. This may take a while. Important: When that finishes, activate the tab labelled "Boot Loader Installation" and select to "Boot from the Master Boot Record". [Yast will often default to booting from the root or boot partition rather than from the MBR but that's for experts only -- always choose the MBR.] Then click Finish to save the changes and install the reconfigured Grub into the hard drive's MBR. If you get a message that "The bootloader boot sector will be written to a floppy disk ......... don't bother with the floppy -- just click OK to proceed and install to the MBR. Reboot and you should be able to boot to openSUSE using the Grub menu screen........
    The quote is from here: GRUB Boot Multiboot openSUSE Windows (2000, XP, Vista) using the Grub bootloader.
    Leap 42.3 & 15.1 &KDE
    FYIs from the days of yore

  3. #3

    Thumbs up Re: Installation of Suse 11.1 Partition and Grub Problems

    Thanks...

    You're an angel!

    I've been struggling with this problem for nearly a month. This is the first place I will come if I have any other problems.

    Thanks once again!
    James

  4. #4
    Join Date
    Mar 2008
    Location
    Oz
    Posts
    11,731
    Blog Entries
    2

    Default Re: Installation of Suse 11.1 Partition and Grub Problems

    You're very welcome
    Leap 42.3 & 15.1 &KDE
    FYIs from the days of yore

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •