Results 1 to 3 of 3

Thread: ATI Crossfire returns Black Screen

  1. #1
    AcuZobs NNTP User

    Default ATI Crossfire returns Black Screen

    Hello,

    I spent some time now to understand how to enable my ATI cards to work in crossfire mode on my SUSE 11.1 64bit

    After some while I found out that the "1-click" method from ATI-HowTo returned black screen for me with no response from computer (except, "Ctrl+Alt+Del" seams to properly restart computer).

    Than following manual installation I can get working my ATI HD4850 card properly. But when I enable the crossfire (using instructions from [Phoronix] ATI Radeon CrossFire On Linux) I get the same black screen. No error do appear in Xorg log files, so I am stuck here...

    If I run Linux in run level 3 and disable the crossfire everything is working again

    Can anyone help me with this? Maybe it is common glitch for new 8.7 ATI drivers ?

  2. #2
    Join Date
    Aug 2008
    Location
    Iowa, USA
    Posts
    162

    Default Re: ATI Crossfire returns Black Screen

    try to reset your resolution to a lower setting and see if that might help. this platform is a very high end gaming platform, and requires a lot of graphics capabilities.


    check the crossfire website for the latest linux updates.also you can reinstall the os and accept the default settings to see if the system will configure automatically for you...

    do a repost if this works.

  3. #3
    Join Date
    Nov 2008
    Location
    N. Wales
    Posts
    1,028

    Default Re: ATI Crossfire returns Black Screen

    AcuZobs adjusted his/her AFDB on Tuesday 04 Aug 2009 12:36 to write:


    > Can anyone help me with this? Maybe it is common glitch for new 8.7 ATI
    > drivers ?
    >
    >


    I take it you meant "9.7" drivers?

    How did you do the initial config after installing?

    Did you use a previous xorg or run the aticonfig --initial command again.

    IIRC if the aticonfig sees that you have already used it to change xorg.conf
    then it will exit gracefully with no change made, however if it finds a
    standard xorg.conf ( one from say the initial install ) that has not been
    touched then it will edit it and configure it for your card.

    If I have done anything to the ATI drivers or installed new ones I always
    replace the existing xorg.conf with a plain standard xorg.conf before
    running the aticonfig command.

    There should be backup xorg`s in /etc/X11 from either the initial install or
    from before you put the first ATI drivers on.

    If not then before you try the aticonfig and if you want to make a clean
    xorg, make a backup of your existing xorg,conf ( something like xorg-ati-
    working.conf ) so that you can get it back easily, drop to runlevel 3,
    login as root and run

    sax2 -r -m 0=vesa

    this should give you a standard one, then run the

    aticonfig --initial

    Then try

    init 5

    See if that makes any difference, it might not YMMV, if it does then use the
    catalyst app to see if you can get crossfire working from there, obviously
    if it all goes pear shaped you just need to copy back the working xorg to
    get back to where you are now :-)

    HTH

    --
    Mark
    Caveat emptor
    Nullus in verba
    Nil illegitimi carborundum

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •