Hi!
I need to configure a HP Procurve Switch over serial-cable. In Windows there is i good term-app that is called TeraTerm. I tought it was very easy to use terminal over serial, but i can’t find out how.
So how can i use terminal over serial?
Hi!
I need to configure a HP Procurve Switch over serial-cable. In Windows there is i good term-app that is called TeraTerm. I tought it was very easy to use terminal over serial, but i can’t find out how.
So how can i use terminal over serial?
install minicom
then start minicom -s to configure the speed and other settings…
Well…
I installed minicom and set port-speed to 9600 8N1 that is the most used configuration.
It claims my Com-port is /dev/tty8. How can i check to see if this is right? In Linux-world there is nothing called com1 or com2.
But isnt there any normal application like Hyperterminal or TeraTerm or Putty for OpenSUSE?
RS
Ok! I solved it!
Com1 is /dev/ttyS0
After i set this right i got in!
RS
Had to look through some old paperwork, but you found out yourself. Always remember this moment !!!