Results 1 to 2 of 2

Thread: Intersil Prism 2.5 openSUSE 11 WPA

  1. #1
    tmaruh NNTP User

    Default Intersil Prism 2.5 openSUSE 11 WPA

    Hi forum,

    I have a big problem with my wireless lan card on my thinkpad a31.
    I read the following howto and manuels but I cannot connect with my wlan card to the access point.

    Netgate: Intersil Prism 2.5 Firmware Info Page

    Jun Sun's mini-HOWTO on flashing Intersil Prism chipsets

    Howto:

    Linux-Firmware-Flashen-Prism2.5-Intersil-WPA-HOWTO

    My situation:
    Code:
    dmesg |grep wifi
    hostap_pci: Registered netdevice wifi0
    wifi0: Original COR value: 0x0
    wifi0: NIC: id=0x8013 v1.0.0
    wifi0: PRI: id=0x15 v1.1.1
    wifi0: STA: id=0x1f v1.7.4
    Code:
    wifi0: Intersil Prism2.5 PCI: mem=0xf8000000, irq=11
    Code:
    02:02.0 Network controller: Intersil Corporation Prism 2.5 Wavelan chipset (rev 01)
    Code:
    hostap_diag wifi0
    Host AP driver diagnostics information for 'wifi0'
    
    NICID: id=0x8013 v1.0.0 (PRISM II (2.5) Mini-PCI (SST parallel flash))
    PRIID: id=0x0015 v1.1.1
    STAID: id=0x001f v1.7.4 (station firmware)
    I got this error code through dmesg:

    Code:
    dmesg |grep wifi
    hostap_pci: Registered netdevice wifi0
    wifi0: Original COR value: 0x0
    wifi0: NIC: id=0x8013 v1.0.0
    wifi0: PRI: id=0x15 v1.1.1
    wifi0: STA: id=0x1f v1.7.4
    wifi0: Intersil Prism2.5 PCI: mem=0xf8000000, irq=11
    wifi0: registered netdevice wlan0
    wifi0: LinkStatus=2 (Disconnected)
    wifi0: LinkStatus: BSSID=00:20:e0:8d:b5:a9
    wifi0: TXEXC - status=0x0004 ([Discon]) tx_control=000c
    wifi0: LinkStatus=2 (Disconnected)
    wifi0: LinkStatus: BSSID=44:44:44:44:44:44
    wifi0: LinkStatus=2 (Disconnected)
    wifi0: LinkStatus: BSSID=44:44:44:44:44:44
    wifi0: LinkStatus=2 (Disconnected)
    wifi0: LinkStatus: BSSID=44:44:44:44:44:44
    wifi0: LinkStatus=2 (Disconnected)
    wifi0: LinkStatus: BSSID=44:44:44:44:44:44
    wifi0: LinkStatus=6 (Association failed)
    wifi0: LinkStatus: BSSID=44:44:44:44:44:44
    wifi0: LinkStatus=2 (Disconnected)
    wifi0: LinkStatus: BSSID=44:44:44:44:44:44
    wifi0: LinkStatus=2 (Disconnected)
    wifi0: LinkStatus: BSSID=44:44:44:44:44:44
    wifi0: LinkStatus=6 (Association failed)
    wifi0: LinkStatus: BSSID=44:44:44:44:44:44
    wifi0: LinkStatus=2 (Disconnected)
    wifi0: LinkStatus: BSSID=44:44:44:44:44:44
    My solution about the dmesg report the wpa didn't work properly.

    Have anybody an idea?

    Regards Thorsten

  2. #2

    Default Re: Intersil Prism 2.5 openSUSE 11 WPA

    I have the exact same problem, did you find a solution for this?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •