Hi all,

I have a broadcom 4318 wireless chip. I read a lot of posts on this forum and installed the b43 driver, but I still have no wireless connection. So a new thread.
Can anybody help me with a suggestion what to do now? I can see a message "timed out" with dmesg, but I don't know how to fix that.

Also I discovered in /var/log 2 files called NetworkManager-date (with date the actual date). The problem here is that these files are big: 770MB and 902MB. I cannot open them because they are just too big. But why are these files that big?

Thanks a lot!
Andr

Output of lspci:
Code:
06:02.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
Some parts out of dmesg (I hope the right ones...):
Code:
b43-phy0: Broadcom 4318 WLAN found
phy0: Selected rate control algorithm 'pid'
Broadcom 43xx driver loaded [ Features: PMLR, Firmware-ID: FW13 ]
(...)
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
input: b43-phy0 as /devices/virtual/input/input10
ACPI: PCI Interrupt 0000:01:05.0[A] -> GSI 17 (level, low) -> IRQ 17
b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
(...)
Registered led device: b43-phy0::tx
Registered led device: b43-phy0::rx
Registered led device: b43-phy0::radio
NET: Registered protocol family 17
wlan0: Initial auth_alg=0
wlan0: authenticate with AP 00:13:f7:2f:2e:a5
wlan0: authenticate with AP 00:13:f7:2f:2e:a5
wlan0: authenticate with AP 00:13:f7:2f:2e:a5
wlan0: authentication with AP 00:13:f7:2f:2e:a5 timed out
ip6_tables: (C) 2000-2006 Netfilter Core Team
ip_tables: (C) 2000-2006 Netfilter Core Team