Results 1 to 3 of 3

Thread: DeLL vostro 1400 with Intel 965 GMA

  1. #1
    purwo NNTP User

    Default

    How to enable/install 3D?
    so i can install beryl.

    PS. I use openSuse 10.2

  2. #2
    Join Date
    Jun 2008
    Location
    Moorsel - Belgium
    Posts
    40

    Default Re: DeLL vostro 1400 with Intel 965 GMA

    This is the place to start
    Beryl - openSUSE

    I should say that Beryl is now replaced by Compiz Fusion.
    You better wait a few days and install opensuse 11 where 3D is enabled by a single click...

  3. #3

    Default Re: DeLL vostro 1400 with Intel 965 GMA

    I have the same system, running openSUSE 10.3.

    To get 3D acceleration, I had to enable the proper modules, which were not loaded.
    Code:
    $sudo modprobe agpgart
    $sudo modprobe intel_agp
    $sudo modprobe drm
    $sudo modprobe i915
    Then I created symlinks for all of the GL libraries from /usr/lib to /usr/X11R6/lib.

    Code:
    $sudo ln -s /usr/lib/libGL* /usr/X11R6/lib
    Finally, I made sure that the glx and dri drivers were set to be loaded in /etc/X11/xorg.conf:

    Code:
    Section "Module"
      ...
      Load         "glx"
      Load         "dri"
    EndSection
    Finally, I reloaded X, and did a glxinfo/glxgears:

    Code:
    $glxinfo| grep direct
    direct rendering: Yes
    $glxgears
    7164 frames in 5.0 seconds = 1432.699 FPS
    7688 frames in 5.0 seconds = 1536.983 FPS
    ...
    Even for onboard, this video is a little laggy.. but it was about 400FPS w/o DRI.

    Good luck!
    Pretend that I did something really geeky like posting my computer specs here.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •