Activity Stream

Reply to my own thread! Looks like this problem: After initial boot messages video cuts out on console... ...

Also only upgrade curl and zypper......... zypper install --force curl libcurl4 zypper zypper-log zypper-lifecycle-plugin zypper-needs-restarting...

PS: You need: zypper in --force ......... to get the new packages Otherwise no switch to new Repos.....

enable the refresh for both repos.......

Timeshift is not the same as snapper. Time shift is a backup scheme, snapper is a sort of like a dif and not a full backup. There are definite...

Thank you, but unfortunately same result :( # zypper lr -d # | Alias | Name | Enabled | GPG Check | Refresh |...

I will try that thanks

Leap 15.3 has 2 more Repos: 18 | repo-sle-update | Update repository with updates from SUSE Linux Enterprise 15 | Ja | (r...

I have used the expert partitioner before with leap. My question (not expressed clearly) is: I still want the equivalent of the snapshots in tw...

@mrmazda: OK, I saw the "local services" but just assumed that meant it or they were installed by user . . . . Still haven't seen the "how-to" to...

Okay, that explanation sounds good to me, why it fails with the libcrypt. Which repos do you have in mind? The packman repo? Because I did this: ...

Hi Disable snapshots and use btrfs (that's what I have here, but 60GB / with 18GB allocated)? If want to use ext4, then during install use the...

Quick update to add a little bit more information: I've just seen that KDE's desktop Software Updates notifier has told me there are a few updates...

I used x2go. And this is work fine on leap 15.2 and old tumbleweed, But on Leap 15.3 and fresh tumbleweed it did not connect to remote session, or...

In the scripts you test the sub-directory /HDD/backup. In the case you change the name of this sub-directory the scripts will fail. As my HDD is...

My printer is a Wlan Printer, I install them first connected with USB, after that connected with Wlan without Problems: As root: hp-setup

Delete both broadcom-wl packages and try the b43 Module. The broadcom-wl packages install a blacklist file in /etc/modprobe.d: grep -i 'blacklist...

I don't think he's using a desktop or terminal emulators, but that he's actually using the terminal interface itself. He said he's using a minimal...

This is the nightmare I'm having atm. My 2nd generation motherboard died and I replaced it with more ram, i5 instead of i3 on a 4th generation board....

From this https://forums.opensuse.org/showthread.php/532159-Wlan-with-Broadcom-wlan-circuit-(BCM4311-802-11a-b-g)-too-slow-problem/page2 this...

Thank you ! Serg

I have an LVM with root part 10G free. --- Volume group --- VG Name system System ID Format ...

Yes, that's what I tried . After reboot - wifi Up. But: b43 module is used, not wl module! look: localhost:~ # lsmod | egrep "b43|wl"...