Tja en toen wilde ik eens tv gaan kijken met Opensuse11.4
De kaart wordt herkend maar ik krijg geen kanalen.
Mythtv setup werkt niet naar behoren kan alleen maar instellen dat ik in NL zit en dan niets.
Xawtv ziet alleen de webcam.
Wat te doen??
Onderstaand wat ik met dmesg krijg.
fd800
7.654375] saa7133[0]: subsystem: 0070:6707, board: Hauppauge WinTV-HVR1120 DVB-T/Hybrid [card=156,autodetected]
7.654435] saa7133[0]: board init: gpio is 40000
7.735398] IR RC5(x) protocol handler initialized
7.814559] IR RC6 protocol handler initialized
7.828508] saa7133[0]: i2c eeprom 00: 70 00 07 67 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
7.828518] saa7133[0]: i2c eeprom 10: ff ff ff 0e ff 20 ff ff ff ff ff ff ff ff ff ff
7.828526] saa7133[0]: i2c eeprom 20: 01 40 01 32 32 01 01 33 88 ff 00 b0 ff ff ff ff
7.828533] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
7.828540] saa7133[0]: i2c eeprom 40: ff 35 00 c0 96 10 06 32 97 04 00 20 00 ff ff ff
7.828548] saa7133[0]: i2c eeprom 50: ff 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
7.828555] saa7133[0]: i2c eeprom 60: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
7.828562] saa7133[0]: i2c eeprom 70: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
7.828569] saa7133[0]: i2c eeprom 80: 84 09 00 04 20 77 00 40 80 f7 61 f0 73 05 29 00
7.828576] saa7133[0]: i2c eeprom 90: 84 08 00 06 89 06 01 00 95 29 8d 72 07 70 73 09
7.828584] saa7133[0]: i2c eeprom a0: 23 5f 73 0a f4 9b 72 0b 2f 72 0e 01 72 0f 45 72
7.828591] saa7133[0]: i2c eeprom b0: 10 01 72 11 ff 73 13 a2 69 79 cd 00 00 00 00 00
7.828598] saa7133[0]: i2c eeprom c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
7.828605] saa7133[0]: i2c eeprom d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
7.828612] saa7133[0]: i2c eeprom e0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
7.828619] saa7133[0]: i2c eeprom f0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
7.828634] tveeprom 1-0050: Hauppauge model 67209, rev C2F5, serial# 6420352
7.828637] tveeprom 1-0050: MAC address is 00:0d:fe:61:f7:80
7.828640] tveeprom 1-0050: tuner model is NXP 18271C2 (idx 155, type 54)
7.828643] tveeprom 1-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L’) PAL(D/D1/K) ATSC/DVB Digital (eeprom 0xf4)
7.828647] tveeprom 1-0050: audio processor is SAA7131 (idx 41)
7.828649] tveeprom 1-0050: decoder processor is SAA7131 (idx 35)
7.828652] tveeprom 1-0050: has radio, has IR receiver, has no IR transmitter
7.828654] saa7133[0]: hauppauge eeprom: model=67209
7.857567] cfg80211: Calling CRDA to update world regulatory domain
7.890770] IR JVC protocol handler initialized
8.004383] usbcore: registered new interface driver snd-usb-audio
8.284022] ALSA ac97_codec.c:2074: AC’97 1 does not respond - RESET
8.284589] ALSA ac97_codec.c:2083: AC’97 1 access is not valid [0xffffffff], removing mixer.
8.485459] IR Sony protocol handler initialized
8.495127] tuner 1-004b: chip found @ 0x96 (saa7133[0])
8.530017] tda829x 1-004b: setting tuner address to 60
8.646761] lirc_dev: IR Remote Control driver registered, major 251
8.647661] tda18271 1-0060: creating new instance
8.648491] IR LIRC bridge handler initialized
8.648701] ALSA intel8x0.c:2241: Unable to initialize codec #1
8.677018] TDA18271HD/C2 detected @ 1-0060
8.700027] intel8x0_measure_ac97_clock: measured 50756 usecs (2448 samples)
8.700030] intel8x0: clocking to 48000
8.772705] cfg80211: World regulatory domain updated:
8.772709] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
8.772713] (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
8.772715] (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
8.772718] (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
8.772720] (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
8.772723] (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
8.788796] b43-phy0: Broadcom 4318 WLAN found (core revision 9)
9.240668] ieee80211 phy0: Selected rate control algorithm ‘minstrel_ht’
9.241623] Registered led device: b43-phy0::tx