Configuring Network Adapter

I'm a newbie in linux.

I've installed open suse 10.3 and using madwifi as driver for my WLAN card (Atheros AR5006 EG).

The problem appear when i'm trying to configure my adapter.

I'm alredy using YAST to configure it, but it doesn't work. The IP and Default gw still wont be used by the adapter.

So I try to configure using ifconfig, and it work..

but i can't still config default gw for my adapter??

Any suggestion for me please..

Did you get to like this panel and there put the IP of the gateway: http://www.swerdna.net.au/wireless/wirelessx.png

Swerdna

Did you get to like this panel and there put the IP of the gateway: http://www.swerdna.net.au/wireless/wirelessx.png

Swerdna
[/b]

I've do that, but still i can't config default gw for my interface ...

Any other suggestion please??
Is there any command on terminal that can be used to config default gw for my interface??

Thanx

I researched this for someone else, so in case you did not see that thread, you could look here:
http://www.suseforums.net/index.php?s=&amp...st&p=245101
and here:
http://www.suseforums.net/index.php?s=&amp...st&p=245117

Are you certain you have an AR5006eg, or could it be an AR5007eg incorrectly identified as an AR5006eg?