[spetrov_bg]

i'm sorry my bad, FC card have 2 ports and i posted wrong/disconnected port information, here is connected port info:

Jul 1 03:26:57 web16 kernel: qla2xxx 0000:08:05.0: Found an ISP2312, irq 32, iobase 0xffffc20003058000
Jul 1 03:26:57 web16 kernel: qla2xxx 0000:08:05.0: Configuring PCI space...
Jul 1 03:26:57 web16 kernel: qla2xxx 0000:08:05.0: Configure NVRAM parameters...
Jul 1 03:26:57 web16 kernel: qla2xxx 0000:08:05.0: Verifying loaded RISC code...
Jul 1 03:26:57 web16 kernel: qla2xxx 0000:08:05.0: Allocated (412 KB) for firmware dump...
Jul 1 03:26:57 web16 kernel: scsi9 : qla2xxx
Jul 1 03:26:57 web16 kernel: qla2xxx 0000:08:05.0: LIP reset occured (f7f7).
Jul 1 03:26:58 web16 kernel: qla2xxx 0000:08:05.0: LIP occured (f7f7).
Jul 1 03:26:58 web16 kernel: qla2xxx 0000:08:05.0: LOOP UP detected (2 Gbps).
Jul 1 03:26:58 web16 kernel: scsi 9:0:0:0: Direct-Access DGC RAID 1 0428 PQ: 0 ANSI: 4
Jul 1 03:26:58 web16 kernel: sd 9:0:0:0: [sdb] 104857600 512-byte hardware sectors (53687 MB)
Jul 1 03:26:58 web16 kernel: sd 9:0:0:0: [sdb] Test WP failed, assume Write Enabled
Jul 1 03:26:58 web16 kernel: sd 9:0:0:0: [sdb] Asking for cache data failed
Jul 1 03:26:58 web16 kernel: sd 9:0:0:0: [sdb] Assuming drive cache: write through
Jul 1 03:26:58 web16 kernel: sd 9:0:0:0: [sdb] 104857600 512-byte hardware sectors (53687 MB)
Jul 1 03:26:58 web16 kernel: sd 9:0:0:0: [sdb] Test WP failed, assume Write Enabled
Jul 1 03:26:58 web16 kernel: sd 9:0:0:0: [sdb] Asking for cache data failed
Jul 1 03:26:58 web16 kernel: sd 9:0:0:0: [sdb] Assuming drive cache: write through
Jul 1 03:26:58 web16 kernel: sdb:<6>sd 9:0:0:0: [sdb] Device not ready: Sense Key : Not Ready [current]
Jul 1 03:26:58 web16 kernel: sd 9:0:0:0: [sdb] Device not ready: Add. Sense: Logical unit not ready, manual intervention required
Jul 1 03:26:58 web16 kernel: end_request: I/O error, dev sdb, sector 0
Jul 1 03:26:58 web16 kernel: printk: 6 messages suppressed.