Hello,
i'm trying to connect OpenSuse 11.0 to my EMC storage system, using qlogic 2342M card and get this errors on /var/log/messages:
1> root# modprobe qla2xxx
--- /var/log/messages ---
qla2xxx 0000:08:05.1: Verifying loaded RISC code...
qla2xxx 0000:08:05.1: Allocated (412 KB) for firmware dump...
scsi10 : qla2xxx
qla2xxx 0000:08:05.1:
QLogic Fibre Channel HBA Driver: 8.02.00-k9
QLogic FCI/O-CARD2Gb/s -
ISP2312: PCI-X (100 MHz) @ 0000:08:05.1 hdma+, host#=10, fw=3.03.20 IPX
qla2xxx 0000:08:05.1: Cable is unplugged...
2> root# fdisk /dev/sdb
Unable to read /dev/sdb
--- /var/log/messages ---
sd 9:0:0:0: [sdb] Device not ready: Sense Key : Not Ready [current]
sd 9:0:0:0: [sdb] Device not ready: Add. Sense: Logical unit not ready, manual intervention required
end_request: I/O error, dev sdb, sector 0
printk: 13 messages suppressed.
Buffer I/O error on device sdb, logical block 0
Buffer I/O error on device sdb, logical block 1
Buffer I/O error on device sdb, logical block 2
Buffer I/O error on device sdb, logical block 3
sd 9:0:0:0: [sdb] Device not ready: Sense Key : Not Ready [current]
sd 9:0:0:0: [sdb] Device not ready: Add. Sense: Logical unit not ready, manual intervention required
end_request: I/O error, dev sdb, sector 0
Buffer I/O error on device sdb, logical block 0
sd 9:0:0:0: [sdb] Device not ready: Sense Key : Not Ready [current]
sd 9:0:0:0: [sdb] Device not ready: Add. Sense: Logical unit not ready, manual intervention required
end_request: I/O error, dev sdb, sector 104857592
any ideas are welcome
