I have got my Broadcom wireless card set up w/ ndiswrapper and cannot
connect to the Internet. I can however ping my wireless router (gateway)
and even pull an IP from it. What I cannot do is get beyond the router. I
am dual booting with Windows XP pro and, I can using the same security
settings (WEP/WPA) connect my laptop to the Internet while in Windows. I
also added my router as a nameserver to the etc/resolv.conf file with no
effect. Is the issues related to IPv6 or something else? Below is a scren
shot of my wlan device after running the iwconfig in the shell. I have
altered my encryption key below for security reasons. I had this working
fine under Suse 9.3, I just cannot figure out what is the problem. Also
is the KDE wireless manager a good tool to use?
IEEE 802.11g ESSID:"thewifihide68" Nickname:"Suse-linuxLT"
Mode:Managed Frequency:2.462 GHz Access Point:
00:11:50:31:CF:AB
Bit Rate=54 Mb/s Tx-Power:25 dBm
RTS thr=2347 B Fragment thr=2346 B
Encryption key
82C-(my encrypiton key)-B99D-EF Security
mode
pen
Power Management
ff
Link Quality:100/100 Signal level:-40 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0